January 9, 2009 on 3:10 pm | By | In bluefreesky.com |
how to test and repair a circuit breaker
The electric outlets(sockets) in all the 3 bathrooms in my house have
stopped working suddenly! I have only used one of them in the last 2
days. All the other sockets/lights etc are working fine.
i checked the circuit breaker in my garage for any blown out fuses..
all seem to be working fine(i tested on the left end of the
breakers..)..
Can you guide me as to how to detect the source of the problem and fix
it.Thankyou for your comment.
the outlets do not have any such buttons. Are the GFI same as these
buttons ?
I checked on the MAins-board. They have only the wide switches, and no
additional buttons.Britian may be different than the USA where I live. Except for houses
more than 70 years old there are no fuses. The circuit breakers look
like broad switches. Occasionally they appear not be tripped, but if
you switch them off then back on they reset and power is restored to
the outlets.
You can test circuit breakers that are removed from the panel with a
small battery and a torch = flashlight bulb or other low voltage
light bulb. The circuit breaker replaces a peice of wire which
completes the circuit. The bulb should light with the breaker on; not
light if the breaker is off or defective. NeilIf all the non-functioning outlets are in bathrooms, you may want
check the GFI (Ground Fault Interrupt). Each of the outlets (if new
enough) may have a small button on them. This is an internal circuit
breaker. Push the button in and see if the outlet starts working
again.
- HammerI'd like to clarify my problem further...
The Main-switches to the whole house are on a single MAIN-board in my
garage. I checked an available end of each of these switches.. and all
of them worked fine. I am not able to find the fuses of each of these
switches though.
What should i do to test and identify the source of the problem and
correct it ?#If you have any other info about this subject , Please add it free.# |
|
edit